Fatigue Tests and Design of Welded T Connections in Thin Cold-Formed Square Hollow Sections Under In-Plane Bending

Mashiri, Fidelis Rutendo; Zhao, Xiao-Ling; Grundy, Paul

doi:doi:10.1061/(ASCE)0733-9445(2002)128:11(1413)

Search Content Type

Search
Advanced Search

You are not logged in to this journal. Log In

Journal of Structural Engineering / Volume 128 / Issue 11 / TECHNICAL PAPERS

Previous Article | Next Article

LOG IN or SELECT A PURCHASE OPTION:

Buy PDF (US$30)
Permissions

Fatigue Tests and Design of Welded T Connections in Thin Cold-Formed Square Hollow Sections Under In-Plane Bending

J. Struct. Eng. 128, 1413 (2002); http://dx.doi.org/10.1061/(ASCE)0733-9445(2002)128:11(1413) (10 pages)

Fidelis Rutendo Mashiri¹, Xiao-Ling Zhao, M.ASCE², and Paul Grundy²

¹Doctoral Candidate, Dept. of Civil Engineering, Monash Univ., Clayton, VIC, 3800, Australia.
²Professor, Dept. of Civil Engineering, Monash Univ., Clayton, VIC, 3800, Australia.

(Submitted 14 June 2001; accepted 12 March 2002)

Alerts
- Alert Me When Cited
- Alert Me When Corrected
Tools
Share
- Email Abstract
- Connotea
- CiteULike
- del.icio.us
- BibSonomy
- Tweet this Article
- Add to Facebook

Abstract

References (30)

Citing Articles (3)

There is an increased use of thin-walled (t<4 mm) hollow sections in the manufacture of lighting poles, traffic sign supports, swing ploughs, linkage graders, trailers, and haymakers. These structures are subjected to fatigue loading. A review of current fatigue design guidelines showed that there is a lack of design rules for nodal joints made up of thin-walled (t<4 mm) hollow sections. This paper describes the tests carried out on welded thin-walled (t<4 mm) tube-to-tube T connections made up of square hollow sections under cyclic in-plane bending. Different failure modes were obtained during fatigue testing. The experimental stress concentration factors determined in this investigation were found to be significantly lower than the stress concentration factors from the existing parametric equations from the International Institute of Welding. The design S_r.hs-N curves have been determined for the hot spot stress method from S_r.hs-N data based on both experimental and parametric equation stress concentration factors. Design S_r.hs-N curves have been derived from the fatigue data using the least-squares method. The design S_r.hs-N curves derived from the experimental fatigue data are lower than the expected design curve resulting from the current trend for design S_r.hs-N curves for different thicknesses from the International Institute of Welding and the International Committee for the Development and Study of Tubular Construction. Three design approaches are proposed for welded T connections in thin cold-formed square hollow sections under cyclic in-plane bending.